Augvape x VapnFagan BTFC 25mm BF RDA (Discontinued)

The Augvape BTFC 25mm BF RDA is made in collaboration with VapnFagan to create a gorgeous two-post build deck rebuildable platform, featuring squonk BF functionality, dynamic airflow channels, and high performance capability. The ease-of-use from the BTFC RDA is largely in thanks to the spacious build deck that accommodates novice and advanced builders alike, but can also be attributed to the two-post layout with graciously large terminals to accept thick or flat coil wires. Coil leads are placed onto the terminal openings, top-side secured via Hex screws for proper connection. Deep juice wells are also available to hold a small reservoir of juice to keep the cotton saturated, and can be topped off by either dripping through the widebore drip tip or pumping an attached juice bottle. The airflow system is controlled by turning the top cap and adjusting the amount of airflow that channels through the bottom air slots. At the top sits two pairs of airflow vents for the Augvape BTFC, inletting air into the inner chamber to maximize the eJuice flavor potential.

Augvape x VapnFagan BTFC 25mm RDA Features:

• Collaboration with VapnFagan
• Deep Juice Well
• Superior Stainless Steel Construction
• Spacious Two-Post Build Deck
• Top-Side Secured via Allen Hex Screws
• Single or Dual Coil Configuration
• PEEK Insulator
• Quad Exterior Slotted Top Airflow Control
• Dual Exterior Slotted Bottom Airflow Control 
• Dual Internal Airtubes Integrated Into Each Post 
• Threaded Top-Fill System
• 810 Delrin Widebore Drip Tip
• Squonk BF 510 Pin
• 510 Connection

Note: When it comes to using RDA, RTA, and RDTA, we strongly recommended to wash and clean all the atomizers thoroughly and carefully. Likewise, please have a great sense of knowledge when it comes to handling and using these products.

We always strongly recommend testing the coils with ohm-meter before using them with your mods, devices and batteries. Coils with low resistance are not suitable with all mods, devices and batteries. Please make sure that your mods, devices and batteries can handle low resistance before using them.

Note: There is always an inherent risk when using any rechargeable batteries at anytime and under any circumstances. ElementVape.com and any of ElementVape.com’s parent and subsidiary companies are not held responsible for any damage for any modification of the batteries, chargers, devices and other products that we carry in any form or shape, this is including pack making.

ElementVape.com and any or all of ElementVape.com’s parent and subsidiary companies will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the improper use of a Li-ion (Lithium-ion), LiPo (Lithium-ion Polymer) and any rechargeable battery/batteries as well as chargers. Please have a greater understanding of the batteries/chargers you are using and how to care for them properly.

When working with Li-ion (Lithium-ion), LiPo (Lithium-ion Polymer) and any rechargeable cells, please be cautious and carefully use as they are very sensitive to charging characteristics and may explode or burn if mishandled. Please make sure that you have great knowledge on all rechargeable batteries before you use them. Always charge batteries at the clean and fire-proof surface. Never leave charging batteries unattended. If you see that there are visible damages on the batteries, please do not use. Always keep, store and transport the rechargeable cells in a safe, non-conductive container in controlled environment.